Sinetica Eagle-i

The Eagle-i is a network attached device, designed to provide room or multi rack level power, environmental monitoring and physical access control, using a single IP address.

The exciting development to this product is the ability to extend the functionality of the base unit by adding external expansion devices, allowing a further increase in the supported number of sensor inputs, power monitoring inputs and controlled relay outputs, allowing greater flexibility.

Features and Benefits

• Supplied as 19” rack mountable unit, housed in a 1U metal case.
• Dual mains feed with dual built in power supplies.
• 6 x power strips, monitoring amps, volts, kVA, kWh, power factor and Hz.
• 12 x input sensor channels; namely temperature, humidity, voltage free contact and 0-10VDC analogue input. 
• 2 x Sinetica serial keypads / smart card readers or two external expansion units.
• 2 x normally open / normally closed relay contacts with a 240VAC voltage switching contact rating.
• 2 x normally open / normally closed relay contacts with a low voltage switching 50VDC/AC contact rating.
• 1 x 12VDC output @ 500mA power supply for solenoid door lock activation.
• Alarms can be used to trigger SNMP traps, e-mail messages, or SYSLOG events.
• The overall system is controlled and monitored over a TCP/IP, 10/100Mbps Ethernet network with network access provided through NMP, HTTP, HTTPS and Telnet. 

The Eagle-i supports the following external expansion units:

• Power Monitoring Hub. This is a 1U non networked device, which allows for port expansion without consuming further network ports. This device supports up to 18 Sinetica power devices, including our intelligent power strips, CL-Amp, In-Line Unit or Multi-device Hubs. When used with the Eagle-i, a total of up to 24 power monitoring devices can be connected.
• Multi-device Hub. This is a 1U non networked device, which allows for port expansion without consuming further network ports. This allows connection of up to 2 Sinetica power monitoring devices, including our intelligent power strips, CL-Amp or In-Line Units, 3 environmental and security monitoring sensors, full control of two electronic door handles, support for two keypads or proximity readers and support for the external LCD display. 

When an Eagle-i and the above expansion hubs are used together, up to 12 dual fed cabinets can be fully monitored and controlled from a single IP address.

Sinetica Eagle-i PDF