Sinetica PowerHawk 2

The PowerHawk² is a cost effective monitoring solution, designed to provide single rack level power and environmental monitoring, using a single IP address. 

The PowerHawk² is an exciting new product that has enhanced the Unite Technologies family of Sinetica branded product portfolio. Its development is largely based on the Hawk-i family of products, but has been designed with simplicity in mind, without the complexity of mass input and output channels that may be excessive for single cabinet installations. The underlying technology and functionality however, has remained the same.

Features and Benefits

• An SNMP agent optimised for rack management. 
• Ideal for single cabinet installations.
• Allows up to two power strips, monitoring, volts, amps, kVA, kWh, power factor and frequency, with the option of supporting a maximum of 24 switched outlets per strip. Alternatively two CL-Amps can be monitored.
• Allows up to two auto sense analogue input channels per cabinet, (combination of temperature, humidity, analogue voltage or open/close contact probes.
• An easy to use web interface for configuration and monitoring attached sensors and power strips.

 The PowerHawk² supports standard network communication protocols TCP/IP, UDP, DHCP, TFTP, SMTP, HTTP, HTTPS and SNMP V1 / V2.1C. All units are shipped with a predefined IP address and mask, which must be used to access the unit for configuration, allowing the user to setup any IP address values for the unit through an HTTP/HTTPS web interface.

The PowerHawk² allows up to 5 SNMP Network Management Station (NMS) addresses to access the unit. Alarm conditions will generate trap messages, which can be directed to a maximum of 10 specified management stations. SMTP alarm trap thresholds may be set on any of the input measured parameters, i.e. volts, amps, kVA, kWh, temperature, humidity and switch states.

Sinetica PowerHawk2 PDF