|
|
||||||||||||
|
||||||||||||
|
||||||||||||
|
|
NetBotz 4-20mA Sensor Pod - NBPD0129Monitor up to four 4-20mA analogue sensors, this sensor pod is compatible with select NetBotz Appliances.
Includes: Cable mounting kit, Installation guide, USB cable. NetBotz's 4-20mA Sensor Pod collects an analogue signal from a wide range of standard third-party 4-20mA sensors, and integrates the information into the NetBotz management system. By integrating these stand-alone devices into the NetBotz solution, they become accessible over the company's IT network, and can be viewed, monitored, and reported on via the network. The 4-20mA Sensor Pod connects to either a NetBotz 500 or NetBotz 420 via USB. It is USB bus-powered, so an external power supply is not required. There are four screw-terminal sensor ports on the EIP 4-20mP Sensor Pod, to accommodate up to four 4-20mA sensors. For connecting three- and four-wire sensors, there is an additional port on the side for supplemental loop power. Examples of 4-20mA and 0-5V analogue sensor equipment:
Compatible with the following Devices: |
|||||||||||
|
Home About Us Datacentre Solutions IP Monitoring Solutions Security Solutions Education Support Partners Case Studies Contact Us Site Map Terms & Conditions |
||||||||||||